Tesla Model S & X Battery Module BMS Cell Tap Board (Gen 3)

Tesla Model S & X Battery Module BMS Cell Tap Board:

This fits Tesla modules with the two ribbon band style Blue/Red plugs. Commonly Used On Gen 3 Modules From 90 & 100kWh Pack’s​

Built to replace the standard Tesla BMS boards found in Tesla Model S and Model X battery modules. Fits 90, and 100 kWh series modules. Designed to work as a cell tap that can relay voltage of all 6 module battery groups and both temperature thermistors to your BMS of choice. Both temperature sensors are 10k thermistors and are NOT polarity sensitive. Not all applications will use both thermistors, but we recommend using at least one of the two for monitoring temperatures to maintain battery health. Comes with 12-pin connector and 16 crimp pins. Crimp pins fit 22-18 AWG cell tap wires. We use these with Orion BMS systems. For all inquires email: sales@stealthev.com

Direct replacement for stock Tesla BMS Board, uses existing connectors from the battery module and uses the stock plastic rivets.

No proprietary software required, just plug-in and go!

~NOTE: Modules with cell tap wires that are soldered to the BMS boards are not compatible with our boards. We recommend just using Molex mini-fit Jr. style plugs direct to the wires.~

~DOES NOT FIT MODEL 3 MODULES~

For best crimping results use Molex Mini-fit Jr. crimper part# 63819-0901. A good alternative would be the Molex 63811-1000 or the Astro Pneumatic 9477. Other crimpers may work as well.
Molex Mini-fit Jr. pin extraction tool part# 11-03-0044.

Contact Stealth EV for more information on the Tesla Model S & X Battery Module BMS Cell Tap Board.